So I gave it a couple of go's and it wouldn't start. I turned it off, and waited a little while, then when I tried to start it back up, it wouldn't start. The only problem I had was when I first started the engine after cleaning, it was running a little sluggish. Have driven the car pretty hard and getting good revs, without any problems. The previouse fault codes were: P2111 and P0121.Īfter cleaning and assembling them back, I've had no faults. I have removed and clean both egr and shudder, and the shudder is opening and closing fine manually. Most likely is the shudder isn't clsoing when the engine is turned off? MVB 074.4: Adaption status: (Run) then it should change to (ADP OK)Īlso, are there any ways to check the antishudder valve, I've been having engine shakes when shutting off the engine. Should I input something in 1, 2 and 3? Where is 4th input? I don't understand the meaning in the ross-tech manual: (EGR)_Valve_Adaptationīut, what do I do from here, I don't understand what "MVB 074.1: min position in volts" means, also the latter "MVB's". I'm trying to figure out how to do a EGR adaptation with vcds.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |